Marmox Multiboard Used By NE Renovation Specialist To Tackle Damp And Cold
- dcb1960
- Nov 1
- 2 min read
A highly experienced contractor, specialising in energy upgrade refurbishments, underfloor heating and heating installations, has cited ease of installation, as well as the waterproofing and high insulation values of Marmox Multiboard, for his practice of using the coated XPS boards for all of his bathroom fit-outs and many other projects.
Richard Percy, a former firefighter, who has been carrying out challenging contracts across the country for the past 15 years and trading as RDP Solutions, recounts: “I work across the North-East and the country as a whole, for underfloor heating and greywater recycling and I have made it my speciality to take on refurbishments which other people say can’t be done! In the case of the very old building where I am currently working in Mitford, Northumberland, the place had been very badly rebuilt in the past, with poor installation to the vaulted ceiling, no cavity closers and all of the pipework run under the floors. In addition, chipboard flooring had been laid over battens on out-of-level concrete."
"This required a full strip out to enable the installation of underfloor heating. Overlapping layers of Kingspan were installed in the roof-space and different thicknesses of Marmox Multiboard installed across the walls and floors in all the rooms. For example, I uprated all the window reveals using 12.5 mm Multiboard.”
During the rebuild, all of the pipework for the plumbing was relocated within the studwork, to allow the Uponor minitec underfloor heating system to be laid across a 40 mm thickness of Multiboards. This ensured the maximum amount of heat was delivered to the occupied room above, creating much improved comfort levels for the occupants. Interestingly, as a proponent of hydronic underfloor heating, he has also adopted the practice of extending it beneath the actual shower tray: in this case, one of Marmox’s own linear wetroom trays. Other products from the Marmox range employed on the contract include the jointing tape, 360 adhesive and special washers for installation of the different thicknesses of Multiboard. Richard concludes:
“I use Multiboard for all my bathrooms – virtually every job I do – primarily for their waterproofing performance, but also because they significantly reduce heat loss and are very straightforward to cut and fit. A lot of people go for a cement-based product in bathrooms, but Multiboard is better and easier to install and in new-build situations it also meets the NHBC guidance.”
Marmox Multiboards are manufactured from extruded polystyrene or XPS encapsulated in reinforced polymer concrete, produced in a range of thicknesses up to 60mm and offer a variety of positive physical characteristics in addition to being fully waterproof. They are both light to handle and easy to cut, while still being able to sustain substantial loadings if required, such as for flooring applications. They further offer good thermal insulation performance, helping to cut condensation risk. Full packs of Multiboard and the ancillary products from the Marmox range were all purchased through the local branch of MKM Building Supplies.
